![]() If you’re reading 1000☑00 hz i.e a varying rate between 9, you’re good. Start Slippi, open the Controllers panel, click Configure (assuming you’ve selected GameCube Adapter for Wii U beforehand) and check the poll rate. You should see the “bInterval” on the line of the WUP-028 set to 1. If you get an “Error 577” message, or the WUP-028 line turns red at this step, check ![]() (It restarts device communication, not your computer) If you’re using a Hitbox adapter, pick “250”.Ĭlick “Restart”. Then, choose “1000” in the Selected Rate drop-down menu. Select WUP-028, then toggle “Filter on Device”. Select “All” in the Devices drop-down menu. (Some people aren’t, in that case, just move on) Open the file when asked if you’re asked to. ![]() Don’t worry over the devices listed on your screen differing from that of this example image (i.e a mouse). The service installation is unrelated to what device you currently have selected, you only need to do it once. ![]() Extract the hidusbf folder.įollow the path as indicated in the image (hidusbf-master/hidusbf/DRIVER), then open Setup.exe. Inside it, you should find two compressed folders, hidusbf and hidusbfn. Extract the hidusbf-master compressed folder.
0 Comments
Leave a Reply. |